Omega-vehicle-security Wireless Sensor System zSeries Instrukcja Użytkownika Pobierz pdf (Strona 12)

2.1b Parts of the End Device (zED-CCELL)

1 8 position DIP switch (under cover), sets the NID and DID of the End Device

(see Section 2.7 for details)

2 Power Switch (under cover)

3 Label for Unit Address, Group No. and Network ID Address (NID)

4 Wall mounting holes

5 Label with model and serial numbers

6 Radio module firmware revision location on label

7 Case’s tray, where the PCB, sensor and batteries are mounted

8 Case’s cover

9 Transmit LED (blue)

10 Four (4) Screws attaching Cover

11 Two (2) C-cell batteries (under cover)

12 External probe/sensor, through cable gland (for zED-TC-x) or quick

disconnect connector . Refer to Figure 2.2a for connector configurations.

13 Antenna Mount

14 Thermocouple (if ordered) removable terminal block connector (under cover)

Figure 2.1b Parts of the End Device (zED-CCELL)

SENSOR

INPUT

MODEL #

SERIAL #

#.#

Unit Addr Group Net. Addr

FRONT

REAR

Warning:

the following parts are

ESD sensitive.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 91 92

Brak uwag

Omega-vehicle-security Wireless Sensor System zSeries Instrukcja Użytkownika Strona 12