
,
Page 4
(DPCIO-CS)
Count Input
Current Sink Input (DPCIO-CC)
4
Reset
Connect through Contact
Closure to Ground
5
Program
Connect to Ground to Enter
Enable
Program Mode
(DPClO-CC)
3
Input A
Current Source Input
(DPClO-CS)
Count input
Current Sink Input
[_Zk
Terminal
Function
Operation
1
Ground
2
Input B
Current Source Input
(DPClO-CC)
PROGRAM MODE ENABLE (All Models)
REMOTE RESET (All Models)
+28
VDC
Sensor
CONTACT CLOSURE COUNT
INPUT
+6
to
(DPClO-CS)
CURRENT SINKING SENSOR
(DPClO-CS)
CURRENT SOURCING SENSOR
SOLID STATE
ADD/SUBTRACT INPUT
95°C
??
Do not recharge lithium batteries
??
Do not dispose of batteries in fire
??
Insert battery with correct polarity
WIRING DIAGRAMS
SOLID STATE ADD/SUBTRACT INPUT
m
key to choose the option you want.
Note:
The reset terminal on the rear panel is still active when
the front reset button is disabled.
Note: To exit the program
mode, disconnect the jumper
between terminals 1 and 5.
WIRING RECOMMENDATIONS
Following these suggestions will increase noise immunity
and lengthen unit life.
Cable: Make the connection between the count source and
the totalizer with a two-conductor shielded cable. Connect
the shield to earth ground at one end only.
Relay
Coil Suppression:
If a relay contact is used as a
count source, suppress the relay coil. This can be accom-
plished with an RC network for AC coils or a diode for DC
coils.
Mounting: Do not mount the totalizer near a solenoid or
other inductive devices. Supply enough ventilation to keep
the totalizer operating within the temperature specifications.
Do not mount this unit in a heavy vibration area.
BATTERYSAFETY
The lithium battery that powers your device contains inflam-
mable materials such as lithium organic solvent, and other
chemical ingredients. Explosion or fire may result if the
battery is not handled correctly. To avoid an accident follow
these guidelines:
??
Do not heat batteries above
Enabling the Front Panel Reset Key
The fourth screen in the program mode allows you to enable
or disable the front panel reset key.
Press the
Komentarze do niniejszej Instrukcji