Omega Vehicle Security Wireless Sensor System zSeries Instrukcja Użytkownika Pobierz pdf (Strona 18)

2.7.3 DIP Switch Setup: Ethernet - Coordinator

Figure 2.9 Ethernet - 4 Position DIP Switch Setup

To set the Coordinator to factory default settings:

1) Slide DIP switch #2 to ON position.

2) Power the Coordinator on and wait about 10 seconds until the Coordinator

fully boots up.

3) Set the DIP switch #2 back to OFF position (it does not matter if the

Coordinator is powered ON or OFF, just make sure that the DIP switch is set

to OFF, otherwise, every time the unit is power-cycled the factory settings will

take over.

FF ON

1 SERIAL

2 DEFAULT

3 DHCP

4 TERMINAL

Coordinator

OFF

(Shown in

"OFF" Position)

1) N/C

2) To change to default factory settings

3) To enable/disable DHCP

4) N/C

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 71 72

Brak uwag

Omega Vehicle Security Wireless Sensor System zSeries Instrukcja Użytkownika Strona 18